You’re offline. This is a read only version of the page.
Chirping or Other Audio Artfacts Heard From ControlSpace Processor
This article provides information about a known issue and an available workaround
This article contains information about the firmware files that are packaged with each version of ControlSpace Designer software.
This article addresses connecting to legacy ControlSpace hardware without a network switch.
This article shows what to do if you see a message stating the File contains Old Node ID Mapping.
Launching the ControlSpace IOCardPgm in Advanced Mode for Firmware Assessments, Upgrades and Downgrades.
This article outlines the basic procedure for programming a ControlSpace CC-64 panel with user controls in a ControlSpace program.
Programming Philosophy for Open Architecture Digital Signal Processors - Working from the Outside In
Programming a ControlSpace CC-16 to Control Multiple Gains
This article describes how to save the current state of a processor to flash without ControlSpace Designer.
Serial Over IP settings for controlling processors, PowerMatch, and PowerShare (Dante model) with a 3rd party controller and Serial Over Ethernet (UDP) settings for controlling endpoints
This article explains how to assign volume control to the ControlCenter CC-1 within ControlSpace Designer.
How to configure a ControlCenter CC-2 with an ESP/EX processor
This article explains how to assign volume control to the ControlCenter CC-3 within ControlSpace Designer and how to wire the GPI port.
This article describes one method of creating a system mute state using the GPI terminals on select Bose Professional processors.
This article explains the main differences between using the Scan and Go Online functions
General tips for wiring a CC-16
This article is a general guide for how to find a device by IP when it is not discoverable in Hardware Manager.
Unable to Run IOCardPgm
How to retrieve a ControlSpace Processor's IP Address via RS232
Two methods for using Wireshark to locate Bose hardware are presented.
This article describes the steps to import Bose Dante firmware files into Audinate's Dante Updater for use in firmware updates.
This Article describes how to use the RS232 Port from a ESP/EX in combination with a Terminal Program at your PC
This article describes how to discover the IP address of an ESP series processor by using the RS232 port.
This article describes how many Serial over IP Connections are possible to a ControlSpace ESP/EX or a networked amplifier
This Article describes which Dante Update File you have to use for an old 2 U ESP-Processor with Dante Card inside