Views:

This article explains how to assign a volume control to a ControlCenter CC-1 within Controlspace Designer software.  The wiring of the ControlCenter CC-1 to the GPI (General Purpose Inputs) of the processor is also shown.

 

Relevant Product(s)

  • ControlCenter CC-1
  • ControlSpace ESP-00
  • ControlSpace ESP-00 II
  • ControlSpace ESP-1240
  • ControlSpace ESP-1240A
  • ControlSpace ESP-1240AD
  • ControlSpace ESP-1600
  • ControlSpace ESP-4120
  • ControlSpace ESP-88
  • ControlSpace ESP-880
  • ControlSpace ESP-880A
  • ControlSpace ESP-880AD
  • ControlSpace EX-1280
  • ControlSpace EX-1280C
  • ControlSpace EX-440C

 

 

Procedure

ControlSpace Designer supports the following programming feature via the GPI port for the CC-1 controller.

Volume Control

Drag and drop any Analog input/output, Gain, or Volume Group to an analog mode control for the GPI port to which this controller is wired. Be sure to select the A– mode for the volume control. Use the A– mode when the volume control potentiometer is 0 Ohms (full counterclockwise) to 10 kiloohms (fully clockwise).

 

Pin-to-Remote Connections

Connections from the RJ-45 connector (TIA/EIA 568B wiring) on the CC-1 zone controller to the CONTROL INPUTS connector on the ControlSpace processor. Use GPI mode A- in CSD.

 

Dip switch settings on the ControlCenter CC-1 are as follows:

Keywords: CC-1, ControlCenter, EX, ESP, GPI
Comments (0)
Add a comment