Views:

This article explains how to assign a volume control to a ControlCenter CC-3 within Controlspace Designer software.  The wiring of the ControlCenter CC-3 to the GPI (General Purpose Inputs) of the processor is also shown.

 

Relevant Product(s)

  • ControlCenter CC-3
  • ControlSpace ESP-00
  • ControlSpace ESP-00 II
  • ControlSpace ESP-1240
  • ControlSpace ESP-1240A
  • ControlSpace ESP-1240AD
  • ControlSpace ESP-1600
  • ControlSpace ESP-4120
  • ControlSpace ESP-88
  • ControlSpace ESP-880
  • ControlSpace ESP-880A
  • ControlSpace ESP-880AD
  • ControlSpace EX-1280
  • ControlSpace EX-1280C
  • ControlSpace EX-440C

 

Procedure

ControlSpace Designer supports the following programming features via the GPI port for the CC-3 controller:

  • Volume Control: Drag and drop any Analog input/output, Gain, or Volume Group to an analog mode control for the GPI port to which the CC-3 controller is wired. Be sure to select the A+ mode for the CC-3 controller. Use the A+ mode when the volume control potentiometer is 0 ohms (full clockwise) to 10 kiloohms (fully counterclockwise).
  • Selector Switch: Drag and drop any parameter set to four individual digital mode GPI controls for each switch position, A through D.

 

Pin-to-Remote Connections

Connections from the RJ-45 connector (TIA/EIA 568B wiring) on the CC-3 zone controller to the CONTROL INPUTS connector on the ESP. Use GPI mode A+ in ControlSpace Designer.

 

Connecting the CC-3 Zone Controller


Connect one CC-3 zone controller to any ControlSpace processor.

Keywords: CC-3, ControlCenter, EX, ESP, GPI
Add a comment