This article describes how to wire a ControlCenter CC-1 to FreeSpace IZA 190-HZ and FreeSpace IZA 250-LZ amplifiers.

Relevant Product(s)

• FreeSpace IZA 190-HZ
• FreeSpace IZA 250-LZ
• ControlCenter CC-1

Procedure

ControlCenter CC-1 controllers have RJ-45 connectors (T568B). The ControlCenter CC-1 connects to the PWR and VOL terminals on the back of the amplifier with bare wire.

1. Connect the RJ-45 end of the Ethernet cable to Main on the back of the controller.
2. On the back of the amplifier, connect the White/Orange wire to PWR. Connect the White/Green wire to VOL.
   
3. On the controller, set DIP switches 3 and 5 to the ON position.  All other DIP switches should be down.
   

Important: When a volume controller is connected, the amplifier also expects that the controller has an A/B switch for source selection. Because the CC-1 does not have an A/B switch, the amplifier will default to Input B.  This means that the input source for the amplifier should be connected to Input B.